Segment Description
Bton Indicates the device is in Normal operating mode; allowing its connection to Smart-Sync Bluetooth Network and
Ethernet or Wi-Fi network.
NTP Indicates its connection to a NTP Server has failed three (3) consecutive times and its UTC time is not accurate.
The red LED flashes during this state.
NoNt Indicates the device is in No Network mode. During installation, when a network is not available, set the device to No
Network mode to allow its connection to Smart-Sync Clocks over the Smart-Sync Bluetooth Network.
When a network is available, the device must be set back to Normal mode (Bton).
For more information, see "No Network mode" on page12.
No Signal Indicates its last connection to an Ethernet or Wi-Fi network failed.
For PoE or Ethernet use, a failed check-in may be due to a network connection cannot be established.
For Wi-Fi network use, a failed check-in may be due to the device is not within range of a wireless signal or the wireless
signal strength is not adequate for normal operation.
If the device is powered by AC or Power over Ethernet (PoE), the yellow LED indicator flashes during this state.
Signal Ok Indicates its last connection to an Ethernet or Wi-Fi network and check-in to OneVue was successful.
LOW When operating solely on battery-backup power, indicates its estimated battery life is less than 25%. It's recommended
to replace the batteries.
Lbat When operating solely on battery-backup power, indicates its battery level is critically low.
Data is not logged or transmitted to OneVue during this state.
Up A firmware update is being applied to the device.
Data is not logged or transmitted to OneVue during this state.
Con The device is in configuration mode. The config icon is also displayed.
Data is not logged or transmitted to OneVue during this state.
To Next Page
Loading...