Primus MB33 - Page 66

64 PROGRAMMING MANUAL 100962 G PUBLICATION DATE 24 JUN 2008.DOC
T THE SPRAY SEQUENCE
• Water or Liquid is injected at Distribution or Low Spin Speed
• No standard water inlets can be programmed in this function.
• The spray inlets can only be programmed at the X & XF - type machines.
• On the other machines the liquid will be injected based on soap supply programming.
• The suggested drum speed value depends on the machine
type.
• The drum speed value can only be programmed within
certain limits.
[50 – 150] RPM and [400 – 600] RPM
• The default Spray speed value is 120 RPM.
• Insert the desired speed value. Press the ENTER button for
confirmation.
• Speed selection at the Spray Sequence :
 1-motor type washing machine : Low spin speed
£ Low spin speed is the default setting
£ No selection is needed
 2-motor type washing machine : Distribute or Low Spin
Speed
£ Distribute is the default setting.
£ Select the Speed Selection from the list and press the
ENTER button for confirmation.
• Only available on washing machines with both : a normal
Open and a normal Closed Drain valve.
• As water will be drained at the Spray sequence, it must be
possible to select the wished drain valve 1 or 2.
• The default Drain valve is Drain valve 1.
• Select the desired Drain Valve by pressing the ARROW
LEFT or RIGHT button.
• Press the ENTER button for confirmation.
• If you don‘t want to get into the supply sub-menu, press the
ARROW DOWN button.
• Press the ENTER button to get into the supply sub-menu.
• Default: all the supplies are switched off.
• Extra supplies can only be programmed if the selection in the
Prewash
|
Wash
|
Cooldown
|
Rinse
|
Final Rinse
|
Soak
|
Flush
|
S
p
ra
y
|
No wash
P:Pr XX Step XX
RPM : _ _ _
P:Pr XX Step XX
Supply ?
P:Pr XX Step XX
Drain valve : 1
1 | 2 | 1+2
P:Pr XX Step XX
Spd : Distribute