1. Drain and clean the fuel tank, run engine until carburetor is dry.
2. Thoroughly clean the cut-off saw; tighten all nuts and bolts (except for adjusting
screws).
3. Remove the blade and loosen the V-belt.
Notes on transport and storage:
1. Avoid knocks and bumps.
2. Abrasive blades must not be exposed to direct sunlight or other sources of heat
during transport and storage.
3. Store the machine in a place free of moisture and heat source, Store the cut-off saw
preferably in a place with consistent temperature. Do not store it near corrosive
liquids.
4. Composite blade must be protected against frost.
Exploded parts views and parts lists
42
To Next Page
Loading...