29
If chain paper feeding is abnormal, please check according to the form below.
Inspection Solutions
Is the release lever is at the position of
this icon ?
Stir release lever to this icon position.
Are the paper holes in the right
position?
Aligning the holes.
Are the two paper clips are too near or
too far from each other?
The distance between the two paper clips will affect
feeding. Adjust it appropriately if not.
Are Paper clips locked or covered? Make sure paper clips are locked and covered.
Is the feeding path unhindered?
The distance between chain paper place and printer
shouldn’t exceed 1m, and the path should be smooth, or
it will cause paper jam.
Feeding by pressing the key when
online?
Feeding key is valid when offline.
Is the paper too thick?
There is a limit to the thickness of paper, please refer to
Chapter 2.2.1.
If failing in rejecting paper, please check according to the form below.
Check Solutions
Is the release lever at the position of
this icon ?
Release lever should be at the icon position when
you use chain paper.
Does the printer reject paper
normally?
Check if the PAPER OUT light is on after rejecting.
If the page length, page heading and page footing are not as good as expected, please check
according to the form below.
Check Solutions
Is the position of the first line too high or
too low?
Adjust it by feeding a little.
Does the page length meet the actual
requirement?
Adjust it by software command mode or EDS switch
settings.
To Next Page
Loading...