28
below.
Inspection Solutions
Are the table lines out of alignment?
Adjust the longitudinal calibration parameters.
If the application software cannot print the selected character or font, please check according to
the form below.
Inspection Solutions
Is the application software properly
installed?
Reinstall it if necessary.
Is the correct font selected?
Make sure the settings are correct, try to transfer the
fonts.
Is the printing character different
from inputting character?
Maybe the national character group setting goes is
wrong, or you select wrong character set. Deal with it
by software.
If the printing result is different from requirement, please check according to the form below.
Inspection Solutions
Is the printout not good as expected?
Select HEX printing, analyze the data from computer, it
can help tracking the path of error.
3)
Paper feeding
If a single sheet paper does not feed smoothly, please check according to the form below.
Inspection Solutions
Is the release lever pushed back the
position of this icon ?
Stir release lever to this icon position.
Feeding by pressing the key in the
online state?
Feeding key is valid when offline.
Is the paper too thick?
There is a limit to the thickness of paper, please refer to
Chapter 2.2.1.
To Next Page
Loading...