Printronix SL5000r - Page 100

100
Chapter 3 Main Menu
NOTES:
Italicized items are available only when Admin User is set to Enable (in the PRINTER CONTROL menu).
1
This menu is available only when you enable Admin User (under PRINTER CONTROL).
2
Appears only if Active IGP Emul is set to PPI emulation.
3
These menus do not display when CT, TN5250, or TN3270 emulation is selected.
4
All three Form Length submenus work in conjunction. When you change the default of one submenu, the
default value in the other two submenus change automatically.
5
All three Form Width submenus work in conjunction. When you change the default in one submenu, the
default value in the other two submenus change automatically.
6
The presence of this menu depends on the LP+ Emulation selection (under PRINTER CONTROL).
Select CPI
Select LPI
Typeface
Horizontal DPI
Vertical DPI
Prop. Spacing
Italic Print
Slashed Zero
Left Margin
3
Right Margin
3
Top Margin
Bottom Margin
Print Char. Set
Define CR code
Auto LF
Define LF code
Control Code 06
Compressed Print
Bold
Elong/Alt. Font
Gothic Typeface
EVFU Select
Upr. Case Select
Slew Relative
Text Position
Host Command
Reset Cmd CFG Ld
Form Length (inches)
3, 4
Form Length (mm)
3, 4
Form Length (lines)
4
Form Width (inches)
3, 5
Form Width (mm)
3, 5
Form Width (char.)
5
P-SERIES XQ
SETUP
1, 6
(page 183)
Select CPI
Select LPI
Typeface
Character Group
Character Set
Primary Subset
Extended Subset
Horizontal DPI
Vertical DPI
Prop. Spacing
Italic Print
Slashed Zero
Left Margin
3
Right Margin
3
Top Margin
Bottom Margin
Print Char. Set
Define CR code
Auto LF
Define LF code
Control Code 06
Control Code 08
Bold
Overstrike
Select SFCC
EVFU Select
Alt. Set 80-9F
SFCC d command
PSeries Dbl High
FF valid at TOF
Text Position
Host Command
Reset Cmd CFG Ld
Form Length (inches)
3, 4
Form Length (mm)
3, 4
Form Length (lines)
4
Form Width (inches)
3, 5
Form Width (mm)
3, 5
Form Width (char.)
5
P-SERIES
SETUP
1, 6
(page 181)
Refer to the Printer
Protocol Interpreter
(PPI) STGL
™
Programmer’s
Reference Manual.
PPI/STGL
SETUP
2
Refer to the Printer
Protocol Interpreter
(PPI) DGL
™
Programmer’s
Reference Manual.
PPI/DGL
SETUP
2