Need help?Do you have a question about the Printronix P4280 and is the answer not in the manual?
General| Brand | Printronix |
|---|---|
| Model | P4280 |
| Category | Printer |
| Language | English |
Troubleshooting steps for the "48 Volt Failed" error message.
Troubleshooting steps for the "Dynamic RAM Fault" error message.
Troubleshooting steps for the "Ham. Bank Hot" error message.
Troubleshooting steps for the "Ham. Coil Open" error message.
Troubleshooting steps for the "Ham. Coil Short" error message.
Troubleshooting steps for the "Ham. Drv. Short" error message.
Troubleshooting steps for the "Mech Driver Hot" error message.
Troubleshooting steps for the "Mech Driver Link" error message.
Troubleshooting steps for "Paper Jam" errors.
Troubleshooting steps for "Paper Out" errors.
Troubleshooting steps for "Platen Open" errors.
Troubleshooting steps for "Ribbon Stall" errors.
Troubleshooting steps for "Shttl Cover Open" errors.
Troubleshooting steps for "Shuttle Jam" errors.
Troubleshooting steps for "Software Error" messages.
Procedure to adjust the timing belt for paper feed.
Procedure to adjust the belt for platen open mechanism.
Procedure to check and adjust hammer phasing.
Procedure to align the paper drive motor pulley.
Procedure to align the paper scale with the print.
Procedure to adjust the platen angle.
Procedure to adjust the platen gap.
Procedure to align the platen open motor pulley.
Procedure to align the ribbon guides.
Procedure to adjust the splined shaft skew.
Procedure for replacing the paper feed timing belt.
Procedure for replacing the platen open belt.
Procedure for removing and installing the hammer bank cable assembly.
Procedure for removing and installing the intermediate cable assembly.
Procedure for removing and installing the multi I/O cable assembly.
Procedure for removing and installing the circuit breaker.
Procedure for removing and installing the control panel assembly.
Procedure for removing and installing the hammer bank cover assembly.
Procedure for removing and installing the shuttle cover assembly.
Procedure for removing and installing the card cage fan assembly.
Procedure for removing and installing the cabinet exhaust fan assembly.
Procedure for removing and installing the hammer bank fan assembly.
Procedure for removing and installing the hammer spring assembly.
To Next Page
