5–42 Replacement Procedures
Paper Guide Assembly (Figure 5–18 )
Removal
1. Prepare the printer for maintenance (page 5–3).
2. Open the printer cover.
3. Remove the hold–down screw (1).
4. Slightly lift the right end and slide the paper guide assembly (2) to the
left. Lift the paper guide assembly off the card cage (3).
Installation
1. Position the paper guide assembly (2) offset slightly to the left on the
card cage (3).
2. While holding the right end slightly elevated, slide the paper guide
assembly (2) to the right and engage the tabs on the underside of the
paper guide assembly with the left edge of the card cage.
3. Slide the paper guide assembly (2) to the right as far as it will go.
4. Lower the right end of the paper guide assembly and install the
hold–down screw (1).
5. Return the printer to normal operation (page 5–86).
To Next Page
Loading...
