Need help?Do you have a question about the Printronix P9212 and is the answer not in the manual?
Provides information about the manual's purpose and scope.
Highlights safety and equipment protection information.
Details standard, Coax, Twinax, and IPDS electrical controls and indicators.
Describes the physical controls for paper handling and alignment.
Lists required tools for field maintenance.
Explains the core printing technique of the P9212.
Details the hammer bank mechanism and how characters are formed.
Describes normal printer function and the different P9212 configurations.
Explains the function and architecture of CCB and LMI controller boards.
Outlines the general approach to printer maintenance.
Provides detailed steps for cleaning the printer's exterior and interior components.
Introduces the chapter and basic troubleshooting principles.
Explains different types of fault messages and their indications.
Covers troubleshooting steps for power, memory, disk, and driver-related hardware issues.
Lists diagnostic tools and procedures for resolving issues.
Covers service position, spring tensioning, tip alignment, and gap/phasing adjustments.
Details adjustments for paper feed belt tension and paper out switch.
Covers ribbon tracking, platen gap, and platen open belt adjustments.
Details preload, spring adjustment, and belt tension for shuttle and counterweight mechanisms.
Covers replacement of key assemblies like Blower, Hammer Bank, and Power Supply.
Details replacement of Control Panel, I/O Panel, and associated cables.
Covers replacement of fans, motors, and other smaller components.
Outlines the procedure for replacing printed circuit boards.
Provides diagrams showing how different boards and components connect.
Details pinouts and connections for major circuit boards like CCB and LMI.
Details pinouts for Coax/Twinax (CT) and CTHI interface boards.
Provides wire data for various cable assemblies used in the printer.
Lists signal mnemonics with their definitions.
Lists common acronyms used in the manual with their definitions.
Shows the layout of components on the Mechanism Driver Board.
Illustrates the placement of PROMs and chips on the CCB.
Shows the component layout for the LMI board.
Details the placement of ICs on the 030 Processor Board.
Provides conversion factors for length measurements.
Provides conversion factors for torque measurements.
Provides conversion factors for mass and density.
Provides formulas for converting between Celsius and Fahrenheit.
Details requirements for ribbons and paper, including type, thickness, and size.
Provides physical dimensions and interface details (type, logic levels, compatibility).
Covers operating temperature, humidity, noise levels, and electrical input power.
Specifies printing speeds for text and graphics, and the monthly duty cycle.
General| Brand | Printronix |
|---|---|
| Model | P9212 |
| Category | Printer |
| Language | English |
To Next Page