6–28
Replacement Procedures and Parts
Paper Motion/Out Detector
1. Unplug the printer power cord from the AC receptacle.
2. Remove the paper supply from the print station and tractors. Remove the
paper chains, paper tent, and wire paper guide.
3. Working from the rear of the paper cabinet, remove the three 5/16 inch
screws that hold the machined and front paper guide assembly in place.
(See Figure 6–10, page 6–46, items #1 and #2.)
4. Disconnect the mate–n–lock connectors, and cut the necessary tie–wraps
to allow removal of the machined and front paper guide assemby.
5. To remove the paper motion/out switch assembly, remove the two 1/4
inch screws securing it to the machined and front paper guide assembly.
6. Reverse the removal procedure to re–install the paper motion/out switch
assembly.
7. When assembly is complete, adjust the paper out switch (page 5–18).
To Next Page