6–27
Replacement Procedures and Parts
Paper Feed Motor and Belt
1. Unplug the printer power cord from the AC receptacle.
2. Remove the paper supply from the print station and tractors.
3. Remove four 1/4 inch screws and the lower paper guide. (See
Figure 6–7, page 6–40, item #16.)
4. Remove the Paper Feed Belt Cover.
5. Loosen the four 5/16 inch nuts that secure the paper feed motor. (See
Figure 6–10, page 6–46.)
6. Slide the new belt onto the paper tractor shaft sprocket and the paper
feed motor sprocket.
7. Adjust the paper feed belt tension (page 5–16).
8. If you are going to replace the paper feed motor, remove the four 5/16
inch nuts that secure the paper feed motor, disconnect the power and
signal cable connector, and remove the motor.
9. Install a new paper feed motor using the 5/16 inch hardware, and adjust
the belt tension (page 5–16).
10. Reverse the removal steps to replace the paper feed belt cover and lower
paper guide.
To Next Page
Loading...
