1–4
Overview
Controls and Indicators
Standard Electrical Controls (Figure 1–1)
Switch or
ON LINE
LCD
NLQ
Function
Toggles the printer on–line and off–line.
Indicator
Status lamps
FF Advances paper to top of form on next page.
VIEW
See above.
Locks and unlocks ENTER switch when pressed with B
switch. Causes display of configuration menus,
submenus, and diagnostic tests.
CONFIG
ENTER
Displays previous parameter in a configuration or
diagnostic test menu.
On when the printer is on–line, off when printer is
off–line. Flash to indicate a fault or warning.
Toggles the printer font between NLQ–10 or DP–10.
Selects one of four predetermined printer configurations.
Enters displayed parameter into printer nonvolatile
memory. Must be unlocked before using.
Clears printer after a fault is corrected. Returns printer to
off–line state from within a configuration menu. Resets
printer to most recently saved configuration when
pressed simultaneously with ENTER switch.
Displays next parameter in a configuration or diagnostic
test menu.
Advances paper for viewing through cover window,
then returns paper to print position.
CLEAR
SET TOF
Sets location of first line of print on a page.
Y
"
B
A
Turns printer on and off: up = on, down = off. This
switch is also a circuit breaker.
NOTE: ON LINE and VIEW are the only switches that operate when the printer
is on–line. The other switches operate only when the printer is off–line.
Power Switch
The Liquid Crystal Display (LCD) displays printer status
and error messages.
(UP)
(DOWN)
(PREV)
(NEXT)
To Next Page
Loading...
