6–36
Replacement Procedures and Parts
Shuttle Motor Belt
1. Unplug the printer power cord from the AC receptacle.
2. Remove the paper supply from the print station and tractors.
3. Remove the flywheel assembly (page 6–9).
4. Discard the old belt, loop the new belt around the flywheel, and
re–install the flywheel assembly.
5. Loop the free end of the belt around the shuttle motor sprocket, and
adjust the belt tension (page 5–36).
6. Install the counterweight assembly (page 6–8).
7. Check and adjust the shuttle and counterweight preload (page 5–28).
8. Check and adjust the MPU gap (page 5–12).
9. Adjust the MPU phasing (page 5–14).
10. Replace all remaining belt guards and covers.
To Next Page