4–20 Adjustment Procedures
Splined Shaft Skew Adjustment (Figure 4–10 )
If lines of print are not parallel with the edge perforations on the paper,
perform the following adjustment.
1. Prepare the printer for maintenance (page 4–2).
2. Loosen the screw (1) securing the adjusting link (2).
3. Adjust the link (2) by raising or lowering the horizontal adjustment
knob (5) to obtain print parallel with paper perforations. Tighten the
screw (1).
4. Return the printer to normal operation (page 4–22).
To Next Page
Loading...
