Chapter 2 Specifications
2-7
Display
Touch Panel
*1 For the setting of Master/Slave, refer to the following section; Chapter 3 Uninstalling / In-
stalling HDD units / CF card units (page3-6)
*2 When using the HDD SLOT1 (Expansion SLOT1) with the CD-ROM drive unit at the same
time, be sure to set the HDD/CF card unit inside the Expansion SLOT1 as Master.
*3 The clock, RTC, built in the PL has fudge error. The range of the error will be between +300
to -300 sec. / month, depending on the PL’s conditions such as lifetime usage or temperature
difference. If you use the PL in a computer network that takes this error seriously, adjust the
clock in regular intervals.
Item Specification
Type 12 inch SVGA TFT color LCD
Resolution W800 x H600 dots (SVGA)
Dot pitch W0.3mm [0.01in.] x H0.3mm [0.01in.]
Effective Display Area W246.0mm [9.69in.] x H184.5mm [7.26in.]
Color/Shade level 260,000 colors
Backlight CFL (Compact Fluorescent Lamp) 2-color-light system
Brightness control 4 levels of adjustment (Controlled by software)
Contrast Adjustment None
View Angles
Horizontal Direction: 120 degrees, Vertical Direction: 100 degrees
(Contrast ratio: CR is 10 or greater, or TYP value)
Display Service Life 50,000hrs.(MTTF) (Backlight display service life is not included.)
Backlight Service Life
50,000hrs. or more (at ambient temperature 25
°C and continuous
operation - a period until backlight brightness decreases to 50% or
backlight starts to flicker)
Item Specification
Type Resistive Film (analog)
Resolution 1024 x 1024
Service Life 1,000,000 times or more
Interface USB or COM4
To Next Page