9
9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 16). To protect the floor or carpet, place a mat under the treadmill.
8. Attach a Wheel (66) to the inner side of each Extension
Leg (63) with a Wheel Bolt (64) and a Wheel Nut (104)
as shown. Do not overtighten the Bolts. The Wheels
should be able to turn freely.
Lift the treadmill frame (see HOW TO FOLD THE
TREADMILL FOR STORAGE on page 13), but do not
latch it. Make sure that the frame is centered between
the Handrails (not shown). Firmly tighten the bolts
used in assembly step 4. Then, lower the frame to the
floor.
63
64
66
104
8
To Next Page
Loading...
Need help?
General