7
3. Attach a Wheel (90) with the 3/8" x 2" Bolt (3)
and the 3/8" Locknut (11) that you removed in
step 1. Do not overtighten the Locknut; the
Wheel must turn freely.
60
3
11
3
90
1
. Make sure that the power cord is unplugged.
R
emove the 3/8" Locknut (11), the 3/8" x 2" Bolt
(3), and the shipping bracket (C) from the Base
(60). Remove the shipping bracket from the
other side of the treadmill. Discard the shipping
b
rackets. Save the Locknuts and the Bolts for
steps 3 and 6.
60
11
C
1
3
2. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the tie securing the Wire Harness (86) to the
Base (60). Locate a tie in the indicated hole in
the Base, and use the tie to pull the Wire
Harness out of the hole.
Attach two Base Feet (88) to the Base (60) in the
locations shown with two Base Foot Spacers
(89) and two #8 x 1" Tek Screws (2). Then, at-
tach two Base Feet (88) with only #8 x 1" Tek
Screws (2).
2
60
A
B
2
53
2
2
88
88
2
86
88
88
89
89
Hole
To Next Page