14. Set ten weight plates into the indicated slots in
the right side of the Weight Rest (42). Next, lift
the two selector pins on a Dumbbell (44), and
slide the selector pins to the adjustment holes
marked "2.5." Place the Dumbbell on the weight
plates. Then, lift the two selector pins and slide
them to the adjustment holes marked "15."
Repeat this step with the other Dumbbell (44).
14
42
Selector
,Pins
Weight
Slots
15. Plug the Power Cord (17) into the Receptacle
(!8) located on the Base (5).
17
16. Make sure that all parts are properly tightened before you use the vibration platform.
12
To Next Page
Loading...
Need help?
General
