Pro-Form CARBON T7 User Manual

10
4. Hold the Right Upright (86) against the Base
(97). Make sure not to pinch the Upright
Wire (88).
Insert two 3/8" x 2 3/8" Screws (3) with two 3/8"
Star Washers (11) into the top of bracket on
the Right Upright (86). Partially tighten the two
Screws into the Base (97); do not fully tighten
the Screws yet.
Next, partially tighten a 3/8" x 1 1/4" Screw
(1) and a 3/8" x 1 3/4" Screw (2) with 3/8"
Star Washers (11) into the bottom of the Right
Upright (86); do not fully tighten the Screws
yet.
Attach the Left Upright (not shown) in the
same way. Note: There are no wires on the left
side.
4
1
2
97
11
86
3
11
88
5. Identify the Left and Right Base Covers (93, 92).
Slide the Left and Right Base Covers onto the
Left and Right Uprights (85, 86) as shown.
92
86
93
85
5
11

Pro-Form CARBON T7 Specifications

General

Running Surface	20" x 55"
Weight Capacity	300 lbs
Motor	2.75 CHP Mach Z™ Motor
Speed	0-10 mph
Display	7" High Contrast Display
Folding	SpaceSaver design with EasyLift Assist
Warranty	10-Year Frame, 1-Year Parts & Labor
Product Weight	203 lbs
Dimensions	73.5" L x 35.2" W x 57.5" H