16
20. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see pages 31 and 32). Note: Extra hardware may be
included.
19. Firmly tighten the three Screws (2, 3, 4) on each
side of the treadmill, and press the Base Covers
(94, 95) into place.
2, 3, 4
2, 3, 4
19
94
95
To Next Page
Loading...
