12
64
36
2
8
8. Set the Console Base (64) face down on a soft
surface to avoid scratching the Console Base.
Remove and save the four 1/4" x 1/2" Screws
(2).
Identify the Left Tray (36). Attach the Left Tray
with four #8 x 3/8" Screws (105).
Next, attach the Right Tray (27) with four #8 x
3/8" Screws (105).
Then, remove and save the four 1/4" x 1/2"
Screws (2).
2
27
105
105
9. With the help of a second person, hold the con-
sole assembly (F) near the right Handrail (84)
and the Left Handrail (not shown).
See the inset drawing. Connect the Upright
Wire (81) to the console wire (G). The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT THE
CONNECTORS PROPERLY, THE CONSOLE
MAY BECOME DAMAGED WHEN YOU TURN
ON THE POWER. Then, remove the wire tie (A)
from the Upright Wire.
9
81
G
A
81
84
G
F
To Next Page
Loading...
Need help?
General