SAFETY WARNING
1. Read the operating instructions before using the
instrument and pay particular attention to all WARNINGS
and CAUTIONS in this instruction manual.
2. Be sure that the cover and the test leads of the meter are
in good conditions.
3. Set the range / function switch at the correct position when
measuring.
4. Make sure to insert the red and the black test leads to
their appropriate jacks. The black test lead should be
connected first when measuring while the red test lead
should be disconnected first after measuring.
5. When the range and function changes, both test leads
should be disconnected.
6. To avoid damage to the instrument, never exceed the
allowable maximum input of each range.
7. Be care of electric shock hazard when the voltage to be
tested is above DC 60V or AC 30V.
8. To avoid electric shock, do not open the battery
compartment cover when making measurement.
9. Remove the test leads from the circuit being measured
before replacing the battery.
10. Do not change the built-in circuit to avoid damage to the
meter.
To Next Page
Loading...
