ENGLISH
7
Radio
“ST” indicator lights up when receiving an FM stereo broadcast with
sufficient signal strength.
Search for a station
1
Press B SRC repeatedly to select TUNER.
2 Press J BAND repeatedly (or press #FM+/
*
AM– on the remote
control) to select the band FM1/FM2/FM3/AM.
3 Press S / T (or press S / T (+) on the remote control) to
search for a station.
You can change the searching method for S / T buttons when pressed.
Press K SEEK repeatedly to change the searching method.
• AUTO1 : Automatically search for a station.
• AUTO2 : Search for a preset station.
• MANUAL : Manually search for a station.
You can store up to 18 stations for FM and 6 stations for AM.
• To store a station: Press and hold one of the number buttons (1 to 6).
• To select a stored station: Press one of the number buttons (1 to 6) (or
press one of the number buttons (1 to 6) on the remote control).
Direct Access Tuning
(using the remote control)
1 Press DIRECT to enter Direct Access Tuning.
2 Press the number buttons to enter a station frequency.
3 Press ENT IW to search for a station.
• To cancel, press
or DIRECT.
• If no operation is done for 10 seconds after step 2, Direct Access Tuning is
automatically canceled.
Other settings
1
Press the volume knob to enter
[FUNCTION]
.
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated.
4 Press and hold to exit.
To return to the previous setting item, press
.
Default: [XX]
[TUNER SETTING]
[AUTO MEMORY]
[YES]: Automatically starts memorizing 6 stations with good reception. ;
[NO]: Cancels.
• Selectable only if [NORMAL] is selected for [PRESET TYPE]. (Page 6)
[MONO SET]
[ON]: Improves the FM reception, but the stereo effect will be lost. ;
[OFF]: Cancels.
To Next Page
Loading...
