31
remaining in the playlist. This next track will be shown with the
green program LED lit to indicate that it is still in the playlist.
4. Using next and previous, move to any other tracks you would pre-
fer to skip, pressing program – to eliminate each track from the
playlist. Once you are in the program mode, the green
program LED will illuminate to indicate a track is in the playlist,
and extinguish for any track omitted from the playlist.
Reviewing a Playlist To review your playlist before playing it:
1. Assemble a playlist and press stop.
2. Without selecting any particular track (while the playlist’s total num-
ber of tracks and total playing time are displayed), press program +.
The display will show the first selection in your playlist.
3. To view the next selection, press program + again, and so on.
4. After you view the last selection, one more press of program + will
cause the display to “wrap around” to the first track in the playlist.
(Alternatively, you may use the next and prev buttons to step through all the
tracks, noting which tracks are included in the program by watching for the green
program LED.)
Deleting a Track
from a Playlist
You may delete any selection from a playlist. To delete a selection:
1. Press stop after assembling a program.
2. Press next or previous until the selection you want to delete ap-
pears on the display (programmed tracks cause the program LED
to light green; non-programmed tracks extinguish it).
3. Press program – ; the display will turn off the green program LED
to indicate that the current track has been removed from the play-
list.
4. Repeat steps 3 and 4 for each selection you want to remove from
your program.
Adding a Track
to a Playlist
You also may add a selection to the end of a previously assembled playlist.
1. From stop, using the next and previous (or the numbered buttons
on the Remote Control), select the track you want to add to your
playlist.
2. Add the selection to your playlist by pressing program +.
3. Repeat steps 2 and 3 for each selection you want to add to your
program. Make sure to press program + after each selection.
Temporarily Ignoring
a Program
If you have created a program for the current disc but would like to temporarily
override it and listen to the entire disc, press program – from stop. The program
LED
will extinguish to indicate the program has been overridden. Pressing pro-
gram+
will restore the program.
Erasing a Program If you have created a program for the current disc but would like to erase it from
memory, press and hold program – until EP (Erased Program) appears in the dis-
play, and the program LED is extinguished.
To Next Page
Loading...
