37
When the last item has been reached, pressing program + will return you
to the beginning of the table. If no button is pushed for more than ten sec-
onds, the CDP will “time out” and return to normal operation.
special commands table
Command Display
positive control for operate L 1
positive control for standby L 2
positive control for display on L 3
positive control for display off L 4
A–B repeat L 5
Numeric Keypad: 1 L 6
Numeric Keypad: 2 L 7
Numeric Keypad: 3 L 8
Numeric Keypad: 4 L 9
Numeric Keypad: 5 L 10
Numeric Keypad: 6 L 11
Numeric Keypad: 7 L 12
Numeric Keypad: 8 L 13
Numeric Keypad: 9 L 14
Numeric Keypad: 0 L 15
Direct Access by Time L 16
display toggle L 17
random L 18
polarity toggle L 19
source toggle L 20
mute toggle L 21
up L 22
down L 23
positive control for mute L 24
positive control for unmute L 25
positive control for selecting CD L 26
positive control for selecting Input 1 L 27
positive control for selecting Input 2 L 28
positive control for play L 29
positive control for pause L 30
positive control for stop L 31
positive control for open drawer L 32
positive control for close drawer L 33
4 MOMENTARILY PRESS THE REPEAT BUTTON TO TRANSMIT THE SELECTED
CODE
Line up the IR window of your remote control with the left side of the dis-
play of the CDP, at a distance of approximately 2"-6". Select the to-be-
learned button on the remote, then fire the selected code from the CDP by
pressing repeat. (If you are uncertain as to how to prepare your remote con-
trol for learning new commands, refer to the instructions provided with the
remote control.)
To Next Page
Loading...
