1.0 Introduction
lECON- F(GC)/F(4C) is an Engine Control / Protection Unit for engines
used for NON DG applications.
lThe controller can measure signals from either MPU or charging
alternator to calculate RPM.
lECON provide choice of Varity of sensor selection from predefined
selection chart
lIn critical operation it is possible to disable or debar tripping of engine via
an external digital input.
l128x64 pixel graphical display enhance convenience in configuration of
controller.
2.0 Protection, Supervision Salient Features
Protection
Low Lube Oil Pressure(LLOP)l
High Water Temp. (HWT)l
Fuel Level l [In ECON-F(4C)only]
Emergency off l
Oil Temperature .l
Charging Alternator Fail/V-Belt failurel
Display and Measurement
Battery Voltagel
Engine Run Hourl
RPMl
Oil Pressure in KG/cm2l
Water Temp in degree centigradel
Oil Temp in degree centigradel
Fuel Level in % l [In ECON-F(4C)only]
Service Hourl
3.0 Digital Output
Seven digital output (Six negative and one positive) are available, four
output contacts programmable
.
Start/Crank (Battery Negative)l
Charging Alternator (Battery positive)l
Solenoid (Battery Negative)l
Annunciation 1 (Battery Negative)l
Annunciation 2 (Battery Negative)l
Annunciation 3 (Battery Negative)l
Annunciation 4 (Battery Negative)l
Hooter (Battery Negative)l
Page - 2
Operating Instructions
To Next Page
Loading...
Need help?
General
