EasyManuals Logo

Prodigit 3312F User Manual

Default Icon
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
56 PRODIGIT
[STATe
] PRESet {SP}{ONOFF}
Command Syntax:
[STATe] PRESet {SP}{ONOFF}{NL}
[STATe] PRESet ? {NL}
Purpose: Reads back whether load is in preset mode.
Description: This command is used to check if the load is in preset mode.
0 = Preset mode OFF
1 = Preset mode ON
[STATe
] SENSe{SP}{ONOFFAUTO}
Command Syntax:
[STATe] SENSe{SP}{ONOFFAUTO }{NL}
[STATe] SENSe {NL}
Purpose: Reads back whether the sense function is ON or OFF
Description: 0 = Sense OFF or Sense AUTO
1 = Sense ON
[STATe
] LEVel {SP}{HIGHLOW} or LEV {SP}{HIGHLOW}
Command Syntax:
[STATe] LEVel {SP}{HIGHLOW }{NL}
[STATe] LEVel ? {NL}
[STATe] LEV{SP}{HIGHLOW}{NL}
[STATe] LEV? {NL}
Purpose: Reads back whether the load is operating at its LOW or HIGH LEVEL
Description: In CC, CR, CV or CP operating modes the user can set 2 LEVELS of
Load current, resistance, voltage or power. The load will read back which level it is
At:
0 = Load operating at low level
1 = Load operating at high level
[STATe
] DYNamic{SP}{ONOFF}
Command Syntax:
[STATe] DYNamic{SP}{ONOFF}{NL}
[STATe] DYNamic {NL}
Purpose: Reads back whether the load is operating in STATIC or DYNAMIC mode
Description: 0 = Dynamic operation
1 = Static Operation
[ STATe
] CLR
Command Syntax:
[ STATe] CLR {NL}
Purpose: Clears the error flag
Description: This command is used for clearing the contents of the PROT and ERR
registers. After execution, the contents of these two registers will be “0”.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Prodigit 3312F and is the answer not in the manual?

Prodigit 3312F Specifications

General IconGeneral
BrandProdigit
Model3312F
CategoryIndustrial Electrical
LanguageEnglish

Related product manuals