3302F Series Mainframe Operation Manual 67
Appendix C: 3302F LAN Installation
1. Connect AC power and the network (LAN) cable to the 3302F mainframe. Connect the other side of
the network cable to the existing network.
2. After inserting the driver CD-ROM, run LAN\ETM.EXE from the CD. The Ethernet Manager screen
will be displayed as shown in Fig C1-1. If the Ethernet Manager window does not appear then, press
F5 to search again (refresh), and check the connections if necessary.
Fig D2-1
3. The connected unit will appear on the list, click it to set the IP Address and Subnet Mask as shown
on the following figure.
To Next Page
Loading...
Need help?
General
