DSO26 User Manual
24
MENU SELECTION
The following menu selections are available:
Xover Sub-menu:
Load a Xover – loads a pre-defined crossover.
Design a Xover – starts the set-up wizard for designing a new crossover.
Store a Xover – stores all output settings as a defined crossover.
Erase a Xover Mem. – erase an individual crossover memory.
Input Set-up Sub-menu:
Gang Inputs - Allows ganging of inputs for stereo operation.
Security Sub-menu:
Locks the unit with a 4 digit code, at one of many user definable levels.
DO NOT ENTER THIS MENU BEFORE HAVING THOROUGHLY UNDERSTOOD THE
WAY THE LOCK-OUT WORKS, AS DESCRIBED ON PAGE 27.
System Sub-menu:
System Status – displays unit info, such as version & internal temperature.
LCD Contrast – adjusts the contrast of the LCD screen.
LED Brightness – adjusts the brightness of all indicator LEDs.
Temperature Alarm – sets a temperature warning threshold in °C.
Wake-up Time – sets time take for unit to pass audio after power-up.
Output Meters – selects whether meters are monitoring pre or post mute.
Filter Q or BW – selects display type for parametric filter screens.
Delay Time/Distance – select units to display delays in (mS/m/ft)
Interface Sub-menu:
Interface Setup – enable/disable interface and set baud rate.
AES/EBU Sub-menu:
Routing Options – select various routing options.
AES Diagnostics – shows complete status of AES signal.
(Only available if the AES/EBU option is fitted.)
To Next Page
Loading...
