PROEL DSO26 - X-Over Sub-Menu; Load a Xover; Design a Xover; Store a Xover

DSO26 User Manual
26
X-OVER SUB-MENU
Load a Xover
Loads a stored crossover from the selection available. Enter accepts the selected name
and loads immediately.
Design a Xover
Opens a wizard to design a crossover. Options include format type, ganging of outputs,
routing and automatic limiter time constants. The table below outlines which options are
available dependant on what type of crossover is chosen for the design.
2 x 2 Way 2 x 3 Way 4 Way 5 Way 6 Way
Out 5
Source:A/A+B
Gang
Outputs:Yes/No
Gang
Outputs:Yes/No
Out 6
Source:A/A+B
Out 6
Source:A/A+B
Auto Limit
TC:Yes/No
Auto Limit
TC:Yes/No
Auto Limit
TC:Yes/No
Auto Limit
TC:Yes/No
Auto Limit
TC:Yes/No
Store a Xover
Stores a X-over (all output settings) to one of 9 locations. Crossovers can be named, using
the same method as memories, with up to 16 characters which appear in the default
screen on the top line of the display.
Erase a Xover Mem
Permits clearing (erasing) of individual crossover memories from the unit. Note that, once
erased, the memory name disappears from the list of recallable locations. If the crossover
memory is currently in use, it’s name will remain on the default screen, and the current
settings will not be changed.