PROEL PLBR24 User Manual

29
2. OPERAION GUIDE
2.1 Begin Programming
2.1.1 Record Enable
1. Press and hold down the Record button.
2. While holding down the Record button, tap the Flash buttons 1, 6, 6 and 8
in sequence.
3. Release the Record button, the Record LED lights up, now you can begin
programming your chase patterns.
NOTE:
The first time you turn on your unit, the default setting of the Record Code is
Flash buttons 1, 6, 6 and 8.
You may change the Record Code to protect your programs.
2.1.2 Security for Your Programs
To protect your programs from any editing by others, you may change the
Record Code.
1. Enter current Record Code(Flash buttons 1, 6, 6 and 8).
2. Press and hold down the Record and Edit buttons at a time.
3. While holding the Record and Edit buttons, tap the desired Flash button to
enter a new Record Code
The Record Code consists of 4 Flash buttons(the same button or different buttons),
be sure your new Record Code consists of 4 Flash buttons.
4. Enter your new Record Code a second time, all channel LEDs and scene LEDs
will flash three times, now the Record Code is changed.
5. Exit Record mode. Tap the Rec Exit button while pressing and holding down the
Record button, release the two buttons at a time, the Record mode is disengaged.
IMPORTANT!!!
Always remember to exit Record mode when you won't continue
your programming, otherwise you may lose control of your unit.
NOTE:
The second time you enter your new Record Code different from that of the
first time, the LEDs will not flash, which means you've failed to change the
Record Code.
When you've entered a new Record Code the first time, and now you want to
cancel the new Record Code, you may press and hold down the Record and
Exit buttons at a time to exit.
16
ambiamento della modalità SPEED tra 5 minuti e 10 minuti
1. Premere e mantenere premuto il pulsante R
ECORD.
2. Premere il pulsante 5 o 10 per 3 volte mantenendo premuto
il pulsante R
ECORD.
3. Il 5MIN o il 10MIN dovrebbe accendersi indicando che lo sli-
der S
PEED è impostato per funzionare nella modalità 5 o 10 mi-
nuti.
NZIONAMENTO MIDI
mpostazione MIDI IN
1. Premere il pulsante F
LASH 1 per 3 volte mantenendo premuto
il pulsante R
ECORD, il display leggerà “CHI” indicando che l’im-
postazione del canale MIDI IN è disponibile.
2. Premere il pulsante F
LASH numerato da 1 a 16 per assegnare i ca-
nali MIDI IN 1-16, il LED del canale attinente si accende indican-
do che il canale MIDI IN è impostato.

PROEL PLBR24 Specifications

General

Brand	PROEL
Model	PLBR24
Category	Home Lighting
Language	English