ProForm 380 P Treadmill User Manual (English)

Other manuals for ProForm 380 P Treadmill

User Manual30 pages

Manual Del Usuario30 pages

Manuel De L'Utilisateur30 pages

Manuale D'Istruzioni30 pages

Simple Manual32 pages

Bedienungsanleitung30 pages

Questions and Answers:

B
Brett SmithJul 31, 2025
What to do if ProForm 380 P power does not turn on?
- H
  housemargaretAug 1, 2025
  If your ProForm Treadmill doesn't power on, first, ensure the power cord is securely plugged into a properly earthed outlet. If needed, use a 3-conductor, 1 mm[2] (14-gauge) cord no longer than 1.5 m (5 ft.). Note that the treadmill isn't compatible with GFCI outlets. Also, check that the key is inserted into the console. Examine the circuit breaker on the treadmill frame near the power cord; if it's tripped (switch protrudes), wait five minutes, then press the switch back in to reset it. Finally, verify the on/off switch near the power cord is in the “on” position.
D
Debbie SmithAug 8, 2025
Why does my ProForm 380 P turn off during use?
- R
  Ryan Santiago Jr.Aug 8, 2025
  If your ProForm Treadmill shuts off during use, first check the circuit breaker located on the treadmill frame near the power cord. If it has tripped, wait five minutes, and then press the switch back in. Ensure the power cord is properly plugged in; if it is, unplug it, wait five minutes, then plug it back in. Also, remove and reinsert the key from the console. Finally, verify that the on/off switch is in the on position.
A
Alexander LongAug 15, 2025
What to do if ProForm 380 P walking belt is off-centre?
- D
  Dana SchwartzAug 16, 2025
  If the walking belt on your ProForm Treadmill is off-centre, remove the key and unplug the power cord. If the belt has shifted left, use a hex key to turn the left rear roller bolt clockwise 1/2 turn. If it has shifted right, turn the bolt counter-clockwise 1/2 turn. Avoid overtightening. Plug in the power cord, insert the key, and run the treadmill briefly. Repeat until the belt is centred.
B
Bobby WrightAug 23, 2025
How to fix ProForm 380 P walking belt slowing down?
- M
  Makayla MooreAug 23, 2025
  If the walking belt slows down when you walk on your ProForm Treadmill, use a 3-conductor, 1mm[2] (14-gauge) cord that is no longer than 1.5 m (5 ft.) if an extension cord is needed. If the walking belt is overtightened, remove the key and unplug the power cord. Using a hex key, turn both rear roller bolts counterclockwise 1/4 of a turn. When properly tightened, you should be able to lift the walking belt 2–3 inches off the platform. Keep the belt centred. Plug the cord back in, insert the key, and run the treadmill for a few minutes. Repeat until the belt is properly tightened.