10
8. Hold a Bolt Spacer (79) inside the lower end of
the Left Upright (73). Insert an M10 x 96mm Bolt
(5) with an M10 Star Washer (8) into the Left
U
pright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (79), M10 x 96mm
B
olt (5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Have a second person
hold the Left Upright Spacer and the Left Upright
against the Base (85). Tighten the M10 x 96mm
Bolts (5) until the heads of the Bolts touch the Left
Upright; do not fully tighten the Bolts yet.
83
73
5
85
7
9
8
8
9. Press a Base Cap (82) into the Base (85).
With the help of a second person, tip the treadmill
so that the Base (85) is flat on the floor.
82
85
9
10. Set the Console (87) face down on a soft sur-
face to avoid scratching the Console. Identify
the Right Handrail (90), which has a large hole
in the location shown. Hold the Right Handrail
near the Console. Attach the console ground
wire to the Right Handrail with a #8 x 1/2" Screw
(22).
Next, insert the console wire into the large hole
in the Right Handrail (90) and out of the top as
shown. Attach the Right Handrail with three
M4.2 x 19mm Screws (1). Make sure that no
wires are pinched. Start all three Screws be-
fore tightening any of them; do not over-
tighten the Screws.
90
10
87
1
1
Large
Hole
Console
Wire
22
Console
Ground Wire
To Next Page
Loading...
Need help?
General