5
Use the chart below to identify the small parts used in assembly. The number in parentheses below each part is
the key number of the part, from the PART LIST on page 18. The number after the key number is the quantity
needed for assembly. Note: Some parts may have been preattached for shipping. If a part is not in the
parts bag, check to see if it has been preattached.
M10 x 76mm Button Bolt (67)–2
M8 x 45mm Button
Bolt (50)–4
M4 x 12mm
Screw (42)–4
M8 Nylon
Locknut (38)–6
M10 Nylon
Locknut (33)–6
M10 Split
Washer (59)–2
M10 x 75mm Carriage Bolt (34)–4
M4 x 19mm Flange
Screw (36)–6
Pedal Arm Bolt Set (40)–2
Wave Washer
(43)–2
M8.5
Washer (55)–2
M8.5 Large
Washer (35)–2
M8 x 25mm Patch
Screw (56)–2
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
I
n addition to the included hex keys, assembly requires a phillips screwdriver , two adjustable
wrenches , a rubber mallet , and a pair of pliers .
1. Identify the Front Stabilizer (10). While another per-
son lifts the front of the Frame (1), attach the Front
Stabilizer to the Frame with two M10 x 75mm
Carriage Bolts (34) and two M10 Nylon Locknuts
(33). Make sure that the Front Stabilizer is turned
so the Wheels (22) are not touching the floor.
1
1
10
22
22
33
34
To Next Page
Loading...
