16
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
t
he optional chest pulse sensor at the same
time, the console will not display your heart
r
ate accurately. See page 22 for information on
the optional chest pulse sensor.
Before using
the handgrip
pulse sensor,
remove the
sheets of
clear plastic
from the
metal con-
tacts. In addi-
tion, make
sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and hold the metal contacts on the handrail—
avoid moving your hands. When your pulse is de-
tected, your heart rate will be shown. For the most
accurate heart rate reading, continue to hold
the contacts for about 15 seconds.
7. Turn on the fan if desired.
Press the Fan button repeatedly to turn on or off
t
he fan. Note: If the fan is on when the walking belt
stops, the fan will automatically turn off after a few
m
inutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
or you may damage the treadmill when you fold
it to the storage position. Next, remove the key
from the console and put it in a secure place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Contacts
To Next Page
Loading...
Need help?
General