4. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin
into the Latch Insert (114) in the left Upright (97), and
tighten the knob back onto the pin.
114
Knob
Collar
Spring
Pin
97
4
7
2. With the help of a second person, carefully tip the
U
prights (97) down as shown. (Note: It may be helpful to
place one foot against one of the Extension Legs [115]
as you tip the Uprights.)
Make sure that the Extension
Legs remain in the Uprights.
Attach each Extension Leg (115) with two Extension Leg
B
olts (80) and two 1/4” Washers (39) as shown.
80
115
80
80
115
97
39
39
2
39
39
3. Attach the four Base Pads (99) to the base of the
Uprights (97) with four 1” Tek Screws (40).
With the help of a second person, raise the Uprights (97)
back to the vertical position.
40
40
97
99
99
3
40
99
99
40
To Next Page
Loading...
Need help?
General
