Erasing Channels
After all channels available in your area have been set
into memory, you can erase unwanted channels by fol-
lowing the steps below:.
1. Select the unwanted channel by using the CHANNEL
A or V button or thechannel selection buttons.
2. Press the MENU button to
turn on the pop up menu.
Press the MENU button
again to select CH MEM-
ORY.
_"CH MEMORY
ANALOG
CLOCK/TIMER
3. Press the + or - button to
move the arrow to MEM-
• ORY ADD.ERASE. Select
MEMORY ADD-ERASE by
pressing the MENU but-
ton.
AUTO MEMORY
SEARCH/SKIP
1>MEMORY ADD
,ERASE
TV/CATV
Manually Searching for and Storing Channels
1. Press the MENU button to
turn on the pop up menu.
Press the MENU button
again to select CH MEM-
ORY.
I_CH MEMORY
ANALOG
CLOCK/TIMER
2. Press the + or - button to
move the arrowto
SEARCH/SKIP. Select
SEARCH/SKIP by press-
ingthe MENU button.
3. Press the - buttonto se-
lect the SEARCH mode.
The TV will retum to the
normal screen after four
seconds.
AUTO MEMORY
PSEARCH/SKIP
MEMORY ADD
-ERASE
TV/CATV
CHANNEL UP/DOWN
SKIP : [ + ]
SEARCH : [-]
4. Press the - button to
erase the stored channel
from memory. The channel
number will change from
green to red.
"IV O7
CHANNEL MEMORY
END ERASE
[+] [-]
Adding Channels
o
Channels that are not in memory can be stored manu-
ally. To manually store a channel, follow the steps
above, but press the + button when MEMORY ADD-
ERASE is selected. The channel will be stored in mem-
ory, and the channel number will change from red to
green.
4. Press the CHANNEL A or V button to start search-
ing. It will stop whenever an available channel is
found.
5. if you do not want to store the channel in memory,
press the CHANNEL A or V button again. To store
the channel in memory, refer to ADDING CHAN-
NELS at the left.
6. Until all desired channels have been stored, retum to
SEARCH/SKIP as described above and press the +
button to return to the SKIP mode.
19
To Next Page
Loading...
