7. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.
6
29
Use these
holes
110
32
34
4
62
59
59
29
29
60
5
102
101
32
4. Attach the Storage Latch (34) and the two Latch
Spacers (110) to the left Upright (32) with two Screws
(29). If there are four holes, make sure to use the
two indicated holes. Be careful not to overtighten
the Screws.
Note: If it is difficult to fold or lower the treadmill, re-
move one or both of the Latch Spacers.
Fold the treadmill to the storage position (see HOW TO
FOLD THE TREADMILL FOR STORAGE on page 10).
5. Attach the lower end of the Right Handrail (62) to the
right Extension Leg (59) with a Screw (29).
Attach the lower end of the Left Handrail (60) in the
same way.
Tighten all parts used in this step and in step 2.
6. Remove the backing from the Adhesive Clip (101).
Press the Adhesive Clip onto the base of the right
Upright (32) as shown. Press the Allen Wrench (102)
into the Adhesive Clip.
6
To Next Page
Loading...
Need help?
General