34
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (E) on the console.
Using a bent paper clip (F), press and hold the
reset button inside the opening, and have a second
person press the power switch into the on position.
Continue holding the reset button until the console
turns on. When the reset operation is complete,
the console will turn off and then turn back on. If it
does not, use the power switch to turn the treadmill
off and then on again. Once the console turns on,
check for rmware updates (see HOW TO USE
THE MAINTENANCE SECTION on page 27).
Note: It may take a few minutes for the console to
be ready for use.
E
F
a
To Next Page
Loading...
Need help?
General
