A1 AirTTL
4
www.profoto.com
General safety instructions
Safety Precautions!
Do not operate the equipment before studying the instruction manual and the accompanying safety.
Make sure that Profoto Safety Instructions is always accompanied the equipment! Profoto products
are intended for indoor conditions use. Do not place or use the equipment where it can be exposed to
moisture, extreme electromagnetic fields, or in areas with flammable gases or dust! Do not expose the
equipment to dripping or splashing. Do not place any objects filled with liquids, such as vases, on or near
the equipment. Do not expose the equipment to hasty temperature changes in humid conditions as this
could lead to condensation water in the unit. Do not connect this equipment to flash equipment from
other brands. Front lens shall be changed if it has become visibly damaged to such an extent that their
effectiveness is impaired, for example by cracks or deep scratches. Equipment must only be serviced,
modified or repaired by authorized and competent service personnel
WARNING – Electrical Shock Hazard – High Voltage!
Do not open or disassemble flashes, generators or lamp heads! Equipment operates with high voltage.
Generator capacitors are electrically charged for a considerable length of time after being turned off.
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as direct
sunlight, fire, or the like.
Caution – Burn Hazard – Hot Parts!
If front lens cracks, it must be replaced before re-use of the equipment. Do not touch front lens during
operation it may reach high temperature.
Note about RF!
This equipment makes use of the radio spectrum and emits radio frequency energy. Proper care
should be taken when the device is integrated in systems. Make sure that all specifications within this
document are followed, especially those concerning operating temperature and supply voltage range.
Make sure the device is operated according to local regulations. The frequency spectrum this device
is using is shared with other users. Interference cannot be ruled out.
Laser radiation
IEC 60825-1, Edition 2.0 (2007-03). Wavelength at room temperature: 660 nm. Power through 7 mm
aperture at 100 mm distance in front of the exit window of the autofocus assist unit at room temperature:
< 300 µW. Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice
No. 50, date June 24, 2007.
Caution: Do not remove, disassemble or manipulate the laser auto focus assist light. Failure to comply
with this caution might lead to possible exposure to hazardous laser radiation.
Final Disposal
Equipment contains electrical and electronic components that could be harmful to the environment.
Equipment may be returned to Profoto distributors free of charge for recycling according to WEEE.
Follow local legal requirements for separate disposal of waste, for instance WEEE directive for electrical
and electronic equipment on the European market, when product life has ended!
CLASS 1
LASER PRODUCT
To Next Page
Loading...
