17
INITIATING RECONDITION MODE
The recondition mode can restore batteries from a deeply discharged state by
equalising the cells (equalisation charge) ensuring they are operating at full capacity.
A recondition charge should be performed periodically to optimise the battery’s health
and performance.
STEP 1
Follow STEPS 1 to 6 of the “Charging Instructions” of this booklet.
Ensure the battery is removed from the vehicle to prevent the battery’s electrolyte
from spilling over and damaging the car or engine bay.
STEP 2 – PRESS THE RECONDITION BUTTON
The charger will be in this mode for 4 hours. During recondition the LCD screen will
display rapid horizontal lines. Upon completion of the recondition, the charger will
proceed to carry out a normal charge on the battery.
STEP 3
Follow STEPS 7 to 9 of the Charging Instructions of this booklet.
LOCKING THE REMOTE CONTROL
Locking the remote control will disable the CHARGE, BAT TYPE & RECON keys from
use. This function is ideal for hire vehicles etc as it prevents the chargers settings from
being altered if the keys are touched. When locked the VOLT/AMP key will still work to
display the volts or amps.
To lock; press and hold the ‘CHARGE’ and ‘BAT TYPE’ keys for 3 seconds until you hear
a beep. This indicates the keys are now locked.
To unlock; press and hold and ‘CHARGE’ and ‘BAT TYPE’ keys for 3 seconds until you
hear another beep. This indicates the keys are now unlocked.
To Next Page
Loading...
Need help?
General
