10
3.4 Connecting to a Smart Device (Bluetooth)
1. Go to your smart device’s App Store (iPhone/iPad) or Play Store (Android) and search for the Jayco
“IntelliJay PM100-BTJ” app. Download this app to your smart device.
2. Ensure Bluetooth is enabled on your smart device and that permission is granted for the app to use
Bluetooth and discover new connections.
3. Open the app and it will begin searching for your system’s PMBTJ-02 Bluetooth node.
When this node shows up in the device list, tap and you will be prompted to enter a pairing code.
4. The default pairing code Is the last four (4) digits of your PMBTJ-02 node’s serial number.
You can nd this serial number printed on the side of the node.
If the Bluetooth node does not show up in the device list, ensure the following:
– You are within close enough proximity to the PM100-BTJ system
– The PM100J transformer is connected to sufcient power and operational
– The Bluetooth node is properly connected to the PM100J transformer
– Your smart device operating system is up to date (iOS 8.0 and higher, or Android 4.4 and higher)
To Next Page
Loading...
Need help?
General
