EasyManuals Logo

Projecta INTELLI JAY PM100-BTJ User Manual

Projecta INTELLI JAY PM100-BTJ
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
13
4.2 Troubleshooting
MAINS
.
VEHICLE
BATTERY
CHARGE FAU LT
DESCRIPTION SOLUTIONS
TROUBLESHOOTING
“FAULT” ashes once every sec.
House battery low voltage alarm.
10V≤ House battery voltage <10.5V.
No starter battery connected.
The house battery needs to be charged
as soon as possible.
“FAULT” ashes once every sec.
“Vehicle Bat.”ashes twice every sec.
House battery low voltage alarm.
10V≤ House battery voltage <10.5V.
Vehicle battery has been connected,
but VCR disconnect.
The house battery needs to be charged
as soon as possible.
“FAULT” ashes twice every cycle.
House battery high voltage alarm.
House battery voltage≥16V.
No vehicle battery connected.
Please consult the distributor, installer or
PROJECTA
“FAULT” ashes twice every cycle.
House battery high voltage alarm.
House battery voltage≥16V.
Vehicle battery has been connected.
Please consult the distributor, installer or
PROJECTA
“FAULT” ashes 3 times every cycle.
PM100J unit over temp alarm.
PM100J is working under PS mode.
PM100J will restart automatically
“FAULT” ashes 3 times every cycle.
“Charge”ashes as 1 sec on then 2
sec off
PM100J unit over temp alarm.
PM100J is working under CHG mode.
Check the ventilation and try to
disconnect some of the less priority loads.
If the fault still exists, please contact the
distributor, installer or PROJECTA
“FAULT” ashes 4 times every cycle.
“Charge”ashes as 1 sec on then 2
sec off. Bulk charging time out alarm.
1. Check the setting of the battery
capacity. It should match the actual
battery capacity.
2. Check the status of the battery.
If the battery is dead, please contact the
battery manufacturer or distributor.
“FAULT” ashes 5 times every cycle.
“Charge” ashes once every sec.
VCR anomaly alarm.
Please consult the distributor, installer or
PROJECTA
“FAULT” ashes 6 times every cycle.
Environment over temp alarm.
PM100J is working under PS mode.
PM100J will restart automatically
“FAULT” ashes 6 times every cycle.
“Charge”ashes as 1 sec on then
2 sec off. Environment over temp
alarm.
PM100J is working under CH mode.
PM100J will restart automatically

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Projecta INTELLI JAY PM100-BTJ and is the answer not in the manual?

Projecta INTELLI JAY PM100-BTJ Specifications

General IconGeneral
BrandProjecta
ModelINTELLI JAY PM100-BTJ
CategoryBattery Charger
LanguageEnglish

Related product manuals