ProLights H150UFC - Basic

H150UFC
6
- 2 - FUNCTIONS AND SETTINGS
2.1 CONTROL PANEL
Access control panel functions using the four panel buttons located directly underneath the LCD Display
(g.2).
Fig.2 - Functions of the buttons
MENU UP/TIMER DOWN/VOLUME STOP
Used to scroll through the
main menu
To scroll through the various
functions in descending order
or activate the timer function
To scroll through the various
functions in ascending or
activate the Volume
To turn o the timer and
Volume functions
2.1 BASIC
1. Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
2. Place the unit on a horizontal plane, remove the screw on the rear panel, remove the side panel, and
then unscrew the tank cap.
3. Pour the Prolights liquid, for smoke water-based, in the tank without exceeding the maximum level
to prevent overow. Collect immediately with a dry cloth to prevent that any liquid enters into the
machine. The unit is not protected against splashing water. If liquid does get inside, do not operate the
machine, but refer for a control, to the nearest authorized service center.
4. The machine only works with Prolights liquid. Any other types of uid can damage the unit. During the
lling operation, the machine must not be connected to the electricity grid. First disconnect the plug
from the socket.
5. Always replace the tank. Check that the suction hose reaches the bottom of the tank.
AVOID THE UNIT REMAINS WITHOUT THE FOG LIQUID: THE PUMP COULD BE DAMAGED.
NOTE
• All fog machines develop condensation around the output nozzle. Because this may result in some
moisture accumulation on the surface below the output nozzle, consider this condensation when in-
stalling your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a minute or