ProLights H150UFC - Button a Programming; Button B Programming; Button C Programming; Button D Programming

15
H150UFC
Press the STOP button to exit the setup menu.
2.20 BUTTON A PROGRAMMING
To program the play of the lights to match at the smoke emission when you press the button A on the
wireless remote control, refer to the following procedure.
• Press the MENU button until the display shows the voice Wireless Settings (Button A).
• Press the UP/DOWN button to select the desired program Button A: M01 - Button A: M10, Button A: C01 - Button
A:C15 or Button A: O (hold to quick scroll).
Press the STOP button to exit the setup menu.
2.21 BUTTON B PROGRAMMING
To program the play of the lights to match at the smoke emission when you press the button B on the
wireless remote control, refer to the following procedure.
• Press the MENU button until the display shows the voice Wireless Settings (Button B).
• Press the UP/DOWN button to select the desired program Button B: M01 - Button B: M10, Button B: C01 - Button
B:C15 or Button B: O (hold to quick scroll).
Press the STOP button to exit the setup menu.
2.22 BUTTON C PROGRAMMING
To program the play of the lights to match at the smoke emission when you press the button C on the
wireless remote control, refer to the following procedure.
• Press the MENU button until the display shows the voice Wireless Settings (Button C).
• Press the UP/DOWN button to select the desired program Button C: M01 - Button C: M10, Button C: C01 - Button
C:C15 or Button C: O (hold to quick scroll).
Press the STOP button to exit the setup menu.
2.23 BUTTON D PROGRAMMING
To program the play of the lights to match at the smoke emission when you press the button D on the
wireless remote control, refer to the following procedure.
• Press the MENU button until the display shows the voice Wireless Settings (Button D).
• Press the UP/DOWN button to select the desired program Button D: M01 - Button D: M10, Button D: C01 - Button
D:C15 or Button D: O (hold to quick scroll).
Press the STOP button to exit the setup menu.
2.24 LED TURN ON MODE
To set the LEDs turn on mode, refer to the following procedure.
• Press the MENU button until the display shows the voice LED Setting.
• Press the UP/DOWN button to select Fog Only if you want the LEDs turn on only during the smoke emis-
sion or Always On if you want the LEDs always turned on.
Press the STOP button to exit the setup menu.
2.25 LED DELAY TIME
To set the interval time between the ending of smoke emission and the LEDs switching o, refer to the
following procedure.