EN 6
2.3.3. Third, unplug the Ethernet cable
If the WiFi test is successful, you can then enable the WiFi
connection by unplugging the Ethernet cable from the IP
Camera. The IP Camera will detect the Ethernet cable
unplugged condition and start the WiFi connection. After the
WiFi is connected, the IP Camera will connect to the Internet
immediately.
Figure 2-7: Unplug the Ethernet
cable to enable the WiFi function
Notice
1. Please remember that the WiFi connection will use a different IP address, you will need to do the
“Auto Search” function in the LiveView again to find the IP Camera again after the WiFi is connected.
2. If you want to switch back to the wired Ethernet connection, just plug in the Ethernet cable into the
IP Camera again. Do not need to disable the WiFi function on the web pages.
To Next Page
Loading...
