Ultra100™ TX2 User Manual
10
Installing Drivers with Existing Windows ME System
The following section details the installation of Ultra100 TX2 drivers on a system that
has Windows ME already installed and running. If you’re installing the Ultra100 TX2
drivers on a system during an installation of Windows ME, see “Installing Drivers
During Windows ME Installation.”
1. After installing the Ultra100 TX2 controller card and configuring the hard
drives, power up the system and boot.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI Mass Storage Controller.”
3. Click on “Next,” and from the generat ed list box, choose “Search for a
better driver than the one your device is using now.”
4. Click on “Next,” and from the generated choices, choose “Specify a
location.”
5. Insert the “Ultra100 TX2 Driver” diskette in drive A:.
6. Type “A:\WIN9X-ME” in the text box that appears.
7. Click on “Next.” A message informing you that Windows ME has found
“Win9x-ME Promise Ultra100 TX2™ IDE Controller” should appear.
8. Click on “Next,” and then on “Finish.”
9. Choose “Yes” when asked if you want to restart your computer. Be sure to
eject the diskette from drive A:.
Confirming Driver Installation in Windows ME
To confirm that the driver has been properly loaded in ME, perform the following steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double -click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI &
RAID controllers.” “ Win9x-ME Promise Ultra100 TX2™ IDE Controller” should
appear.
To Next Page
Loading...
Need help?
General