Ultra100™ TX2 User Manual
25
The “F6” key was not pressed at the appropriate time. Reboot the system, and press
the “F6” key when the message “Setup is inspecting your computer’s hardware
configuration…” appears in Windows NT4 or the message “Press F6 if you need to
install third party SCSI or RAID driver” appears in Windows 2000.
Problem:
While booting Windows NT 4.0 or Windows 2000 during a CD-ROM disk install, the
message “No Hard Drives Found” appears.
Solution:
The “F6” key was not pressed at the appropriate time. Reboot the system, and press
the “F6” key when the message “Setup is inspecting your computer’s hardwar e
configuration…” appears or the message “Press F6 if you need to install third party
SCSI or RAID driver” appears in Windows 2000.
Problem:
Miscellaneous problems such as the Ultra100 TX2 BIOS not appearing during boot, the
Ultra100 TX2 driver not loading, or slow data transfer rates.
Solution:
Move the Ultra100 TX2 to a different PCI slot.
Getting Help
Additional tips and troubleshooting instructions are available on the Promise
Technology, Inc. Web site (www.promise.com).
To Next Page
Loading...
Need help?
General