Ultra100™ TX2 User Manual
21
Netware 5
For new NetWare 5 servers:
1. Start the Netware 5 installation as you normally would.
2. When you reach the point in the installation where you install storage
adapters, choose “Modify” in the “Options” window and press ENTER.
3. Highlight the “Storage Adapters” field and press ENTER.
4. Pr ess the INSERT key on your keyboard to “Add” a device.
5. Insert the Ultra100 TX2 driver disk into your A: floppy drive.
6. Press the insert key again to “Add an unlisted driver”.
7. Press F3 and type “A:\NETWARE” in the “Specify a directory path:” window.
Press ENTER.
8. The ULTRA.HAM driver should be listed in the “Select a driver to install:”
window. Press ENTER to select this driver.
9. If you need to install any additional drivers for other storage adapters,
choose “Yes” in the “Do you want to select an additional st orage driver?”
window. If not, choose “No”.
10. Choose “Return to driver summary” in the “Additional Driver Options”
window and press enter.
11. Choose “CONTINUE” in the options window and press ENTER.
12. Continue the installation as you would normally.
For existing NetWare 5 servers:
1. From the System Console type “load NWCONFIG”.
2. Choose “Driver Options”.
3. Choose “Configure disk and storage device drivers”.
4. Choose “Select an additional driver”.
5. Press the INSERT key on your keyboard.
6. Insert the Ultra100 TX2 driver disk into your A: floppy drive.
7. Press F3 and type “A:\NETWARE” in the “Specify a directory path:” window.
Press ENTER
8. The ULTRA.HAM driver should be listed in the “Select a driver to install:”
window. Press ENTER to select this driver.
To Next Page
Loading...
Need help?
General