Ultra100™ TX2 User Manual
9
Windows ME
Installing Drivers During Windows ME Installation
The following details the installation of the Ultra100 TX2 drivers while installing
Windows ME (with the Ultra100 TX2 controller card already in place). If you’r e
installing the Ultra100 TX2 drivers on a system with ME already installed, see
“Installing Drivers with Existing Windows ME System.”
1. Install Windows ME fully.
2. After installation, go the “Start” menu and choose “Settings.”
3. From the “Settings” menu, choos e “Control Panel.”
4. In the “Control Panel” window, double -click on the “System” icon.
5. In the “System” window, choose the “Device Manager” tab.
6. In the hierarchical display under “Other Devices” is a listing for “PCI Mass
Storage Controller.” Choose it and then press the “Properties” button.
7. Choose the “Driver” tab in the “Properties” window, choose “Update Driver,” and
then press “Next.”
8. Choose “Search for a better driver than the one your device is using now
(recommended),” then press “Next.”
9. Choose “Specify Location,” and then type “A: \WIN9X-ME” in the text box.
10. Insert the “Ultra100 TX2 Driver” diskette into the A: drive.
11. Press the “Next” button. A message informing you that Windows ME has found
“Win9x-ME Promise Ultra100 TX2™ IDE Controller” should appear.
12. Press “Next,” then “Finish,” then “Yes” when asked if you want to restart your
computer. Be sure to remove the diskette from drive A:.
To Next Page
Loading...
Need help?
General